I will attach a corrected version of your program, as I think you meant it to work.

That immediately causes rung 14 to activate the B3:1/4 Manual Bit, which stops the system. For downloading LogixPro Click on download file. for complete playlist follow this link-Let’s Go. Rung 10 causes it to halt as soon as the tank is full, because the tank starts off empty and the Low Level Switch I:1/3 is ON, latching your flag B3:1/3 TANK EMPTY. T his playlist going to help you in learning PLC with the help of LogixPro Simulator from Alenbredly. Put them in a logical order: Step 1 FILL, Step 2 MIX, Step 3 HEAT (apparently, but the original LogixPro exercise calls for heating before mixing - resolve this conflict), then LAST should be the Step 4 DRAIN.Īs is, you program cannot operate. That makes it hard to follow your non-logic. For all of you that want a little helping hand with your college/school project. You have your steps jumbled up and out-of-order in the program. Exercise 2 for traffic light simulator on logix pro 500. There should be no other conditions for O:2/6 other than NOT O:2/5.ģ.

If it is NOT in RUN mode (O:2/5 RUN Lamp is OFF), then it is in IDLE mode and O:2/6 should be ON. The Batch Simulator is either in RUN mode, or it is not in RUN mode. This is a binary case of either ONE, or the OTHER, but never both. The LogixPro Student Resources and Programming Exercises are designed to aid the student in mastering the fundamentals of RSLogix operations, programming and troubleshooting using TheLearningPit's LogixPro PLC simulation software. Rung 001: you do not need the parallel branch with I:1/3 Low Level Switch. This indicates that you do not know how the program works, and do not understand what each rung is supposed to do.Ģ. No rung comments, a sure way to knock off 10 points!. I see a few things that I would use to reduce your homework score.ġ.

Logixpro batch simulator exercise 3